Guardall rascal installation manual

Select the supplier or trade you require, enter your location to begin your search. Please select a service and enter a location to continue You must log in or sign up to reply here.

Show Ignored Content. Related Threads. Replies: 3 Views: Replies: 2 Views: JonM63 5 May Replacing a Honeywell Mk7 Keypad graeme.

Replies: 8 Views: GalaxyGuy 15 Apr Replies: 6 Views: DIYNovice 22 Jan Replies: 1 Views: Replies: 2 Views: 1, Share This Page Tweet. The FX zone is omitted by key 6 and the IX zone is omitted by key 5. Any zones that have been pre programmed for high security may not be omitted by the above procedures. An error tone will be given.

The pre set home set zone indicators will pulse omitted. If control has not been pre programmed by the engineer for the home set facility, when the 6 key is pressed an error tone will be given and the home set mode will not be selected. In the home set mode any activation to an alarm zone, not a personal attack zone, will result in a local audible alarm only. Police response will not occur. Enter the allocated four digit user code to silence the internal sounder, investigate and cure the cause of the tamper alarm.

After clearing the fault, enter the user code and press the key, this will switch the control panel on, reset the tamper condition and switch the control panel back to day mode. If the fault cannot be cleared after the above procedure has been followed, the tamper L.

The L. To reset the control panel enter the user code and press the key, this will switch the control panel on, reset and switch the control panel back to day mode. If a zone has not been pre programmed by the engineer for chime facility, when the zone number is pressed an error tone will be given and the control will revert back to day mode.

Duress is obtained by entering one number higher or lower on the first digit of the valid operating codes. The panel can be turned on or off with the duress code, the display will be suppressed until the second entry of a valid code when a reset will be required. The duress facility is only available if the engineer has selected the option during programming.